scanner & linux

rjcb · October 9, 2005

Salut,

J'ai installé une imprimante sous ma FC4. (HP PSC 1610 multifonctions)

La aucun pb. PAr contre je voudrais pouvoir scanner: donc j'ai suivi ceci

et j'ai essayer la deuxième méthode

Par contre je ne sais pas comment vérifier que les 3 démons sont actifs.

J'ai donc trouvé aussi cela

J'ai fais exactement la meme chose, mais a chaque fois que je fais scanimage -L j'ai tjs le meme message:

No scanners were identified. If you were expecting something different,

check that the scanner is plugged in, turned on and detected by the

sane-find-scanner tool (if appropriate). Please read the documentation

which came with this software (README, FAQ, manpages).

[root@rjcserveur ~]# sane-find-scanner

# No SCSI scanners found. If you expected something different, make sure that

# you have loaded a SCSI driver for your SCSI adapter.

# Also you need support for SCSI Generic (sg) in your operating system.

# If using Linux, try "modprobe sg".

found USB scanner (vendor=0x03f0 [HP], product=0x4811 [PSC 1600 series]) at libusb:001:014

# Your USB scanner was (probably) detected. It may or may not be supported by

# SANE. Try scanimage -L and read the backend's manpage.

# Not checking for parallel port scanners.

# Most Scanners connected to the parallel port or other proprietary ports

# can't be detected by this program.

Merci de votre aide

rjcb · October 11, 2005

Salut,

J'ai suivi l'installation pour FC4 et aucun pb.

PAr contre je ne peux pas accéder à l'outil de config HP

GNOME: Click the Menu button, point to Accessories, and then click HP Device Manager.

KDE: Click the Menu button, point to Utilities, and then click HP Device Manager.

Note: Note: You can also open the HP Device Manager by entering this command in the console window: $ hp-toolbox.

The HP Device Manager is displayed.

Meme le hp-toolbox ne marche pas.

cela m'indique command no found

Merci

Recommended Posts